QR Printer Setup

4BARCODE 4B-3044TG
For IT / Admin use only. Run the setup script on every Windows PC that needs to print QR labels. All computers and the printer must be on the same network.
Step 1 — BarTender Base Driver

Must be installed before the 4BARCODE driver.
Only needed if the setup script cannot download automatically.

Download BarTender Driver Install first, then follow Step 2.
Step 2 — 4BARCODE Driver

Install this after the BarTender base driver.
Only needed if the setup script cannot download automatically.

Download 4BARCODE Driver Size: ~40 MB
Step 3 — One-Click Setup

Download and double-click the setup script.
It will automatically download and install all required drivers, connect to the network printer, and configure all three label stocks.

Download Setup Script (.bat) Right-click → Run as administrator
Label Stock Configuration
Manual setup required after printer installation. As per the your requirement.
How to add QR Sticker size in Printing Preferences
  1. Go to → Control Panel → Devices and Printers
  2. Find and click 4BARCODE 4B-3044TG in the list
  3. Click Printing preferences
  4. In the window that opens, click the Page Setup tab
  5. Click the New button
  6. Enter the Name, Width, Height, Left liner and Right liner from the cards above
  7. Click OK to save — repeat steps 5–7 for all 3 stocks
1. Dispatch / Shipment QR
Stock Name Dispatch-100x150
Label Width 100.0 mm
Label Height 150.0 mm
Liner Left 2.0 mm
Liner Right 2.0 mm
Used for Dispatch QR
2. Product QR
Stock Name Product-38x25
Label Width 79.0 mm
Label Height 25.0 mm
Liner Left 2.0 mm
Liner Right 2.0 mm
Used for Products QR
3. Components QR
Stock Name Components-25x15
Label Width 101.6 mm
Label Height 15.0 mm
Liner Left 2.0 mm
Liner Right 2.0 mm
Used for Components QR
Troubleshooting
Make sure your PC and the printer are on the same network/subnet. Try pinging the printer IP from Command Prompt: ping <printer-ip>. The script will ask for the printer IP — ensure it matches the IP shown on the printer's LCD panel.
Right-click Install-QRPrinter.bat → Properties → check Unblock at the bottom → OK. Then right-click again → Run as administrator.
Open Devices and Printers → right-click 4BARCODE 4B-3044TG → Printing Preferences → Stock tab → select Order-Shipment-100x150 → OK.